Home / VTU / Materials / Industrial Drives And Applications Notes VTU | IDA Notes VTU

Industrial Drives And Applications Notes VTU | IDA Notes VTU

Industrial Drives and Applications Notes VTU – IDA Notes VTU of Total Modules

Please find the download links of Industrial Drives and Applications Notes VTU | IDA Notes VTU are listed below:

Link: Complete Notes

PART – A

Link: Part A Notes

UNIT – 1

AN INTRODUCTION TO ELECTRICAL DRIVES & ITS DYNAMICS:Electrical drives.Advantages of electrical drives. Parts of electrical drives, choice of electrical drives, status of dc and ac drives, Dynamics of electrical drives, Fundamental torque equation, speed torque conventions and multiquadrant operation. Equivalent values of drive parameters, components of low torques, nature and classification of load torques, calculation of time and energy loss in transient operations, steady state stability, load equalization.

Link:Unit 1 Notes

UNIT – 2

SELECTION OF MOTOR POWER RATING:Thermal model of motor for heating and cooling,Classes of motor duty, determination of motor rating.

Link:Unit 2 Notes

UNIT – 3 & 4

DC MOTOR DRIVES
(a) Starting braking, transient analysis, single phase fully controlled rectifier, control of dc separately excited motor, Single-phase half controlled rectifier control of dc separately excited motor.
(b) Three phase fully controlled rectifier control of dc separately excited motor, three phases half controlled rectifier control of dc separately excited motor, multiquadrant operation of dc separately excited motor fed form fully controlled rectifier. Rectifier control of dc series motor, chopper controlled
dc drives, chopper chopper control of separately excited dc motor. Chopper control of series motor.

Link:Unit 3 & 4 Notes

PART – B

Link: Part B Notes

UNIT – 5 & 6

INDUCTION MOTOR DRIVES
(a) Operation with unbalanced source voltage and single phasing, operation with unbalanced rotor impedances, analysis of induction motor fed from non-sinusoidal voltage supply, starting braking,transient analysis.
(b) Stator voltage control variable voltage frequency control from voltage sources , voltage source inverter control, closed loop control, current source inverter control, current regulated voltage source inverter control, rotor resistance control, slip power recovery, speed control of single phase induction motors.

Link:Unit 5 &  6 Notes

UNIT – 7

SYNCHRONOUS MOTOR DRIVES: Operation form faced frequency supply, synchronous motor variable speed drives, and variable frequency control of multiple synchronous motors. Self-controlled synchronous motor drive employing load commutated thruster inverter.

Link:Unit 7 Notes

UNIT – 8

INDUSTRIAL DRIVES: Rolling mill drives, cement mill drives, paper mill dries and textile mill drives.

Link:Unit 8 Notes

Check Also

VTU

VTU Updated May 2017 Results of B.E. / B.Tech V & VII (Crash/Extricating) Semester

Visvesvaraya Technological University, Belagavi yesterday updated the results for BE and B.Tech. courses on its …

Leave a Reply

Your email address will not be published. Required fields are marked *